|
Yes, for the cost I'm pleased with the result, which is why I don't mind spending a little more on an SSD for it now.
I could do the mods myself - I've built PCs from scratch since the 90s including HTPCs so it's no big deal, but this case suits me just fine for a cheap gaming PC (which was the aim - cheap!). I've got some spare cases including a UVEM and two other HTPC cases that I could use if I needed to. I just wanted to point out the potential problems others may have to deal with if they wanted to re-case the Dell SFF into a larger case so they can use full height graphics cards. If looks didn't matter, there's nothing stopping you fitting a full height GPU (provided it didn't exceed the PSU) and leaving the lid off. Or cut a slot in the lid so it can be refitted with just the GPU poking out (cooling would be interesting - half in, half out of the case). Heath Robinson would be your man for that
This guy did a nice mod with the card inside using a PCI extender:
Found a video for the Heath Robinson mod too
I think the front panel header that contains the on/off switch and HDD lights can be used with the normal two pin connectors that come with new cases by removing the mobo connector shrouding, either using a Dremel or carefully breaking it away, and then the connectors can fit just like on any other motherboard. I'm not sure if the button assembly can be remounted onto the new case in a way that would look 'original', but it shouldn't be too hard (but probably fiddly) to strip the wires down from the header cable and identify them so they could be reterminated inside the case and then connected to the new case connectors. As you say though, HDD light are nice to have but not essential.
If I come across an SFF cheap enough it would be an interesting project, but I've no real use for it unless I could sell it on without a loss. |
|