Looking good there Hyperfish. I'm sure you'll be able to wet sand that run out once it's hardened, then buff it up again. Done it often myself, especially when I got a new spray gun and wasn't used to the feel of it...you soon learn though.
Yep, just enough would be great but out of the two alternatives I reckon too much is better than not enough. Minimises the risk of cutting through when sanding.
Sanding the finish today. I didn't fancy spending several hours hand sanding the whole body, so I tried the random orbit sander where I could.
I had to keep it moving quite quickly to make sure I didn't cut through but I got away with it. The top and back took about 3 minutes. The sides were not easily accessible with the sander so I did those by hand. Then I wet sanded the body and sides with 1200 grit.
A quick wipe with a damp cloth.
Then I went in with T-Cut on the drill mounted buffer sponge.
All the orange peel and runs are now levelled out.
But a wipe down with Ronson fluid shows a few blemishes that need redoing.
..and then while carrying it I bumped it on the corner of the worktop and did this, FS.
Which I have drop filled and waiting for it to dry.
I bought a cheap replacement pickguard but the quality wasn't anywhere near that of the original which got wrinkled during removal. So I decided to try and repair it.
Sandwiched between a chopping board and a baking tray, heated the tray with the hair dryer and clamped tight.