Hi.
To be honest I am not sure how it is set up. I just installed it and it worked. However when inset up my plunger it is something I will need to figure out as I will probably rip out the current circuit board for controls and let zebsboard do it all
Hmmmm, yours was pre configured wasnt it ? So you must have something configuring your controls, do you have x360ce.exe in your pinballfx3.exe directory ? you can check exactly where its (pinballfx3) installed by right clicking it in steam, go down to properties, then click the local files tab
I installed pinballfx myself . The system must already be set up to use the basic pinball FX controls as they essentially work. I am not at home to check now. When I fix up my table I want to properly set it up however so I can add it properly into ponballX front end (at the moment pinballFX is totally separate from pinballx
I wonder if they did something funky with the USB interface then. When you get a chance could you post your PinballX.ini file please ? Just the Keycodes and Joycodes bit would do.
Sure. Do I just upload a file the same way I did with the photo?
Will do it tomorrow hopwfully
Its coming along slowly. I bought a used HP Elitedesk 800 SFF off ebay for £130, it came with a decent 8gb ram and a i5 4590, I upgraded the hard drive to a ssd and fitted a low profile 1050ti. The pc didnt quite fit with the screen in place so i chopped a bit off, replaced the power switch with a longer one and fitted a new power button on the front which im very pleased with. It plays pinball fx3 great. Before I can finally assemble it im waiting for some brackets so i can pop the screen on and off for any maintenance and the toughened glass wont arrive for a few days.
Just stumbled across this thread. How did your build go?
I am about to start my own data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7